new guy 82 waggy

General Discussions for FSJ Related Topics

new guy 82 waggy

Postby weekend 4 wheelers » Mon Feb 11, 2013 8:26 pm

hey, im from kirby tx. i run a 4 wheel drive club. had an 89 ford bronco and sold it. had an 87 waggy when i was still wet under the ears with 4wds. had to sell it for medical reasons and now i finally got another waggy.
Image

i got a 1982 jeep wagoneer, dana 44 front, amc 20 rear :banghead: , np208 t case, 4.2l straight 6. has 181000k on the body. transmission was rebuilt and the motor also has been rebuilt. 4wd works great. i got the shifter on the floor. it says 2hi 4hi N 4lo. i guess this is a command trac. it has locking hubs (look like factory) has all crank windows (love them) and has a/c heat ect. i bought it for 2000 from an old guy that kept every receipt for the steering linkages, bushing bearings, fluid changes, rebuilds, ect. almost everything on this thing has been rebuilt or replaced. and the 4wd was only used once to pull a boat out of a launch ramp. (t case was rebuilt when transmission was done)
Image
Image
this is what i want. just a lot better looking and desert tan, black grille, trim u get the picture
Image

my plans are to find some dodge or ford dana 60s and put under this thing full width. and chop the fenders to run 37s ot 38s. cross over steer, and shackle flip the rear. sell the dana 44 and amc 20. rock sliders, hood vents, electric fan (push type). and build a t case skid. bumpers winch ect... this is all down the road but this is the plan

questions
1. how do i find the gear ratio with out dumping fluid and checking the ring gear? (curious for when i sell it i wanna know what i got)
2. were do i look to find tranny information? tag? stamp? ect.....
3. who has some one tons they will give me. :D
weekend 4 wheelers
Forum Newbie
Forum Newbie
 
Posts: 3
Joined: Sat Feb 09, 2013 3:24 pm

Re: new guy 82 waggy

Postby ShawnQ » Mon Feb 11, 2013 8:34 pm

I'm a newbie also...unfortunately this forum seems dead. Not many posts. Most forums had their last post in 2012 :?

The easiest way to find the gear ratio if it isn't stamped or tagged anywhere is to lift it up, spin the wheels and count the revolutions of the drive shaft in relation to the axle revolutions. SHould be able to get really close, close enough to know which ratio it is.

For what it's worth, I'm from the U.C. area, attended Judson right down the street from you. Small world.

Did you buy that Wagoneer off of Craigslist? I've been eyeballing a few of them in the S.A. area and that looks like one of them. Now that I'm down by Houston/Galveston it's too long of a drive to go check them out on a whim. Most of the ones I have seen here are rusted fairly bad.

Keep posting progress. Maybe between the two of us we can make this forum active again!
ShawnQ
Forum Newbie
Forum Newbie
 
Posts: 4
Joined: Wed Feb 06, 2013 4:00 pm

Re: new guy 82 waggy

Postby weekend 4 wheelers » Mon Feb 11, 2013 10:41 pm

I went to Judson also. Class of 05 I found this one on craigslist.
weekend 4 wheelers
Forum Newbie
Forum Newbie
 
Posts: 3
Joined: Sat Feb 09, 2013 3:24 pm

Re: new guy 82 waggy

Postby ShawnQ » Mon Feb 11, 2013 10:49 pm

I graduated 01.

Keep us updated on the project.
ShawnQ
Forum Newbie
Forum Newbie
 
Posts: 4
Joined: Wed Feb 06, 2013 4:00 pm


Return to General FSJ Discussions

Who is online

Users browsing this forum: No registered users and 0 guests

cron