Harmonic balancer

General FSJ Technical Discussions

Harmonic balancer

Postby Mike W » Tue Jul 27, 2010 7:39 pm

I have a question regarding the installation of the harmonic balancer on a 360. I used a installer tool from Auto Zone, and thought it was installed properly. I had it torqued to 90 pounds and thought all was well. But when I put on the pulley's, I noticed they did not quite line up. I pulled off the pulley's and harmonic balancer bolt and discovered it was not flush with the end of the crank shaft. There is a 3/8" difference. Is it supposed to be flush, or is this gap normal. This is my first harmonic balancer install.
Mike W
Forum Newbie
Forum Newbie
 
Posts: 3
Joined: Tue Jul 27, 2010 7:28 pm
Location: McKinney, TX

Re: Harmonic balancer

Postby Elliott » Tue Jul 27, 2010 9:03 pm

I think they do go flush, and IIRC there is a big flat washer under the bolt that presses it down...
Elliott
Site Admin
Site Admin
 
Posts: 412
Joined: Tue Apr 21, 2009 6:54 pm

Re: Harmonic balancer

Postby Mike W » Wed Jul 28, 2010 5:10 am

Thanks Elliott,

That is what I thought. I will reinstall it.
Mike W
Forum Newbie
Forum Newbie
 
Posts: 3
Joined: Tue Jul 27, 2010 7:28 pm
Location: McKinney, TX

Re: Harmonic balancer

Postby serehill » Fri Apr 22, 2011 3:54 am

Be careful that the bolt isn't bottomed out. Mine did that when I changed from a 3 bolt HB to a 4 bolt HB I had to get a shorter bolt to get it pulled down.
serehill
ShadeTree Mechanic
ShadeTree Mechanic
 
Posts: 16
Joined: Wed Apr 20, 2011 7:31 am


Return to General FSJ Tech

Who is online

Users browsing this forum: No registered users and 1 guest

cron