BODY: Body-Lift Bumper Bracket Mod

Locked - Only Moderators Can Add a Thread

BODY: Body-Lift Bumper Bracket Mod

Postby Murphy » Tue Apr 21, 2009 1:34 pm

Here's the way I did my bumper brackets for a 2" body lift on my 81 Wag.

The original bracket horns fit inside the bumper so there is no way that I can see for someone to make any kind of adapter bracket. You basically have to raise the bumper bracket.

I removed the rear brackets and straightened the part that wraps underneath the rear frame cross member in a vise with a crescent wrench.
Image

Then I welded it 2" higher.
Image

As you can see I needed to weld one side of the part that I bent down so the bracket wouldn't be too weak side to side.
Image

The front brackets I cut off flush with the front frame cross member and used a piece of 1/4" flat bar to weld inside the cut bracket piece because there is nothing to weld to on the top half of where the bracket needs to go.
Image



It was much easier than I thought it would be.

.
Murphy
 

Return to FSJ Tech Archives

Who is online

Users browsing this forum: No registered users and 1 guest

cron