Re: AMC V8 Dual PS Pump Brackets

[Elliott]

$85. shipped priority for the full unpainted bracket set, bolt kit including zinc plated steel spacers.
View my ebay listing at: http://www.ebay.com/itm/300656434292?it ... m=&vxp=mtr

>>>These will ship with metric pump bolts unless you specify your pump is std thread with the flared hose fitting. (Unless you've put a round can reservoir on your std pump, any factory or aftermarket round can pump will most likely be metric with the 0-ring hose fitting.<<<

If you aren't a member here but want to contact me you can go to my hydroboost page at IFSJA to get my ebay listings and contact me through ebay: http://www.ifsja.org/forums/vb/showthread.php?t=106056
Or.... you can just email me at:

sterlingworth16 at yahoo dot com

[Elliott]

This shows how the parts orient on the pump for installation:

[Elliott]

Here it is fit to the AMC V8:



Here is how you will want to plumb it:



If you move your radiator overflow tank to another spot this is one place you can locate the remote reservoir for this pump setup:

[Elliott]

If you want to see more pics of how I worked this up from scratch then check out my thread in the Offroad FSJ Tech section at:
viewtopic.php?f=5&t=166

[Elliott]

If you need a pump with the round can reservoir I try to keep a couple of those on hand to sell @ $45.
Occassionally I get a request for the AMC PS brackets so I also try and keep a set of those available @ $45. (these brackets aren't being sold separately, just if you are buying dual pump brackets as the dual pump system is what I'm trying to help guys put together and I can't get these brackets very often).

[Elliott]

I still have these brackets.

[Elliott]

I have a couple of sets left before I make another parts run at the laser shop...

[Elliott]

I'm currently working with a new laser shop to offer these cheaper, sold out of all that I currently have but I'm not far from having more of these brackets in stock....

[Elliott]

I have a new supply of these in stock now.

[Elliott]

Pricing adjusted to reflect the cost decrease in the laser work.

[Elliott]

I have kits ready to ship for these....

Contact me here, on ebay at sterlingworth16 or email me at:

sterlingworth16 at yahoo dot com

[Elliott]

Have a few sets of these left

[Elliott]

Had a whole new batch of these cut so if you are interested get a hold of me or check them out on ebay.
Thanks all

[Elliott]

bump

[Elliott]

still selling these, sell quite a few actually