$65.50 if you have air two pump brackets but need all the bolts and spacers to fit the PS pump.
$72. for just the four brackets, painted and shipped priority.
$83. shipped priority for the brackets and a bolt kit if you source the spacers.
$105. shipped priority for the full bracket set, bolt kit including zinc plated steel spacers.
>>>These will ship with metric pump bolts unless you specify your pump is std thread with the flared hose fitting. (Unless you've put a round can reservoir on your std pump, any factory or aftermarket round can pump will most likely be metric with the 0-ring hose fitting.<<<
If you aren't a member here but want to contact me you can go to my hydroboost page at IFSJA to get my ebay listings and contact me through ebay: http://www.ifsja.org/forums/vb/showthread.php?t=106056
Here's a cheaper option: $39.50 for just the two pump brackets, painted and shipped priority.I tried to get it to do this when I revised the last rotation on the pump and found it will work in some circumstances. If you don't have HEI, or do have HEI and didn't use a longer fan belt on your PS pump to add clearance you could retain your original front airpump bracket and the belt tensioner bracket and only use two of the brackets I'm selling. You can also eliminate the one 3/8" spacer between the two front brackets and stack some washers in there to take up ~1/8". That would cut the cost of the brackets in half for you. I've checked it out and it would work like that. It puts you very near the end of the adjuster bracket slot but it works.











