.030 Rebuilt motor that’s been run and gone back through, rods & mains gapped a .002 when I cleaned it up.
Performer manifold, lifters, push rods, felpro gaskets, all accessories including AC pump, flow kooler
$950 without the HEI, exhaust manifolds, carb/air cleaner, starter, bell, flywheel, clutch
If you want the HEI and Edelbrock carb let me know, make offer on those.
Also installed:
Bull Tear stainless oil fill tube
New rear main seal
New fan clutch
Double roller T-chain and gears
I don’t recall what the cam was.
Have a set of new Edelbrock chrome valve covers if wanted.
I can pallet and ship via Forward Air, no charge except the shipping which runs around $300. If you are in TX, OK, LA I'll work with you on delivery.
This was rebuilt to .030, ran for awhile and then sat after bending a pushrod and wiping the cam. I've gone through it, replaced the cam, lifters, pushrods, timing chain/gears, checked the main/rod bearings, installed a new rear main seal, cleaned it up, installed an Edlebrock intake, attached all the accessories, have it on an engine test stand I'm not quite finished with so I haven't started it. These exhaust manifolds aren't for sale but I have others (air tube threaded) if needed.
Need a TH400? T18? let me know...
Main
Rear Main
Rod